Mafell LO 55 Traduction De La Notice D'emploi Originale page 27

- Always lead the connecting cable away from the
machine to the rear while milling.
- An even feed during milling increases the life time
of milling cutter and machine and achieves a clean
milling pattern. Always mill in counter direction when
machining edges.
- Only put down the machine after switching off once
the milling cutter has come to a standstill or unscrew
the clamping for the automatic reverse stroke on the
machine. The machine is locked by releasing the
column clamping lever 18 (Fig. 2).
- Milling cutters must be replaced in good time, as
blunt milling cutters do not only increase the danger
of backlash, but also place an unnecessary strain
on the motor. The milling cutters must be clamped
in accordance with chapter 5.3.
- The wood dust arising during milling impairs the
necessary view and is partly injurious to health. If
the machine is used for longer periods, it must
therefore be connected to a chip extractor, e.g. a
portable small extractor, if the work is not carried out
outdoors or in a sufficiently ventilated room. The air
velocity must be at least 20 m/s.
Stationary use:
- Any stationary use, even on work tables, is
prohibited.
Instructions on service and maintenance:
- Regularly cleaning the machine, especially the
adjusting devices and guides, constitutes an
important safety factor.
- Only original MAFELL spare parts and accessories
may be used. Otherwise the manufacturer will not
accept any warranty claims and cannot be held
liable.
4 Layout
4.1 Depicted components
(see Fig. 1 and 2)
(1) Depth stop
(2) Handle depth stop
(3) Scale for the depth stop
(4) Optical fibre speed adjustment
(5) Speed push button
(6) Speed reduction button
(7) Power-on lock
(8) Handle
(9) Connecting cable
(10) Switch trigger
(11) Hose connector
(12) Wing screw for support foot
(13) Wing screw to fasten parallel guide
fence,
deflector and template guides
(14) Base plate
(15) Revolving depth stop with grub screws
(16) Fine adjustment depth stop
(17) Cam lever
(18) Column clamping lever
(19) Handle
5 Setting / adjustment
5.1 Mains connection
Prior to commissioning make sure that the mains
voltage complies with the operating voltage stated on
the machine's rating plate.
5.2 Chip and dust extraction
Chips arising during milling as well as hazardous dusts
arising from certain materials can be extracted by
means of a commercial vacuum cleaner or with an
external dust extractor.
To do so, attach the hose end of the vacuum cleaner
to the hose connector 11 (see Fig. 2) of the base plate.
For improved extraction, an additional extraction
adapter can be used (included in the scope of supply).
-27-
extraction adapter, chip