Mafell LO 55 Traduction De La Notice D'emploi Originale page 24

2.3 Technical data
Operating voltage
Mains frequency
Input power continuous operation
Idling speed normal operation
Idling speed throttled operation
Speed cooling run
Milling depth adjustment with fine adjustment
Revolving depth stop
Tool fastening with collets
Hose connector diameter
Weight without mains cable
2.4 Emissions
The declared noise emission values have been measured in accordance with DIN EN 62841-1 and may be used
for comparing the tool with another and also in a preliminary assessment of exposure.
2.4.1 Noise emission specifications
Noise emission values determined according to EN 62841-1 and EN 62841-2-17:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
The noise level measurement was carried out with a new straight-edged milling cutter (Ø 12 mm).
2.4.2 Vibration specifications
The typical hand-arm vibration is 2.9 m/s
The measuring inaccuracy is 1.5 m/s
2.5 Shafts of the milling cutters
The shafts of the milling cutters must meet the safety requirements to EN 847-2. The shaft diameter must be of
h8 quality:
- Shaft diameter 8mm: ø 7,978 - ø 8
- Shaft diameter 6mm: ø 5,982 - ø 6
- Shaft diameter 1 / 4 ": ø 6,328 - ø 6,35
Danger
The noise emissions during actual use of the power tool can differ from the declared
values depending on the ways in which the tool is used especially what kind of
workpiece is processed.
Always wear hearing protection, even when the power tool ist running idle in addition
to the trigger time!
.
2
.
2
230 V~
50 Hz
1100 W
10000 - 24000 rpm
10000 - 16500 rpm
8000 rpm
0 - 55 mm
3-stage
Ø 6 – 8 mm
26 mm
3.1 kg
L = 97 dB (A)
PA
K = 3 dB (A)
PA
L = 89 dB (A)
PA
K = 3 dB (A)
PA
-24-