Publicité
Les langues disponibles
Les langues disponibles
3
Safety instructions
Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
Also read the safety instructions in
the enclosed booklet "Safety
instructions".
General instructions:
- Children and adolescents must not operate this
machine. This rule does not apply to young persons
receiving training and being supervised by an
expert.
- Never work without the protection devices
prescribed for the respective operating sequence
and do not make any changes to the machine that
could impair safety.
- When operating the machine outdoors, use of an
earth-leakage circuit-breaker is recommended.
- Damaged cables or plugs must be immediately
replaced. Replacement may only be carried out by
Mafell or an authorised MAFELL service workshop
in order to avoid safety hazards.
- Avoid sharp bends in the cable. Especially when
transporting and storing the machine, do not wind
the cable around the machine.
- Only use milling cutters approved for manual feed.
- Only begin milling the workpiece when the milling
cutter has achieved its full speed.
- Only put down the machine after switching off once
the milling tool has come to a standstill.
Do not use:
- Cracked and misshapen milling cutters.
- Blunt milling cutters as they impose an excessive
load on the motor.
- Milling cutters that are not suitable for the milling
idling speed.
Instructions on the use of personal protective
equipment:
- The noise pressure level at the ear generally
exceeds 85 dB(A). Therefore wear ear protectors
during work.
- Wear protective goggles during work.
- Wear a dust protection mask to prevent health
damage.
- Danger of cuts when changing the milling cutter.
Therefore, wear protective gloves when changing
the milling cutter.
Instructions on operation:
- Never reach into the working range of the milling
cutter or underneath the base plate while the
machine is running (danger of injury)!
- Firmly hold onto the machine with both hands at the
handles provided already before switching it on.
- Provide a free and non-slip location with adequate
lighting.
- The power plug must be pulled before replacing
tools,
making
malfunctions (this also includes removing jammed
chips).
- Examine the workpiece for foreign objects. Do not
mill into metal parts, e.g. nails (danger of backlash).
- Before starting up, check the tight seat of the milling
cutter and its correct running.
- Only use milling cutters approved for manual feed.
- Only use sharp and undamaged milling cutters. You
will achieve improved surfaces and reduce the
danger of backlash.
- Do not work on workpieces that are too small or too
large for the capability of the machine.
- Only hold the power tool by the isolated handles, as
the milling cutter could encounter and cut into its
own connecting cable. The milling cutter contacting
a "live" wire may render exposed metal parts of the
tool "live" and could cause the operator to suffer an
electric shock.
- Use clamps or another practical way to secure and
support the workpiece to a stable support. Holding
the workpiece only with your hand or against your
body leaves it unstable and may lead to loss of
control.
- Only begin milling the workpiece when the milling
cutter has achieved its full speed.
-26-
adjustments
and
repairing
Publicité
