Installing the batteries
Remove the battery cover from the Remote Control and insert 2 x AAA size batteries (not
supplied) into the battery compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.
Observe the correct polarity (+/-) when inserting the batteries and replace the battery cover.
Close the cover.
Install batteries.
Open the cover.
Using the remote control
To use the Remote Control, point it towards the front of the set top box. The Remote Control has
a range of up to 7 metres from the set top box to an angle of up to 60 degrees.
NOTE:
The Remote Control will not operate if its path is blocked.
Sunlight or very bright light will decrease the sensitivity of the Remote Control.
EN-5