Publicité
Les langues disponibles
Les langues disponibles
C
6, With curved ends down, slide end
plates (C) of brush roll into slots (E) on
tool.
7. Replace belt guard (B) making sure
not to pinch brush bristles in guard. Turn
agitator, making sure it rotates freely.
Replace and tighten screws.
8. To replace bottom plate (A), insert the
four tabs on edge of bottom plate into
slots on front of tool.
Pivot bottom plate down and snap
closed.
Powered
hand tool
Belt
replacement
The powered hand too] belt is designed
to last a long time and is net normally
replaced. However, if the belt is crack-
ed, gouged or broken, it should be
replaced.
Replacing
belt
When replacing belt, ask for HOOVER
part No. 38528037.
1. Remove bottom plate, belt guard and
brush roll as described
in Figs. 3-19
through 3-21.
4. With flat sides of turbine retainers (G)
pointing down, slide retainers into
grooves (H) in tool housing and snap
into place.
5. Replace brush roll, belt guard, and
bottom plate as described
in Figs. 3-21
through 3-24.
The belt can be seen through the top of
the nozzle or by removing the bottom
plate and belt guard (Figs. 3-19 and
3-20.
2. Grasp turbine (E) and pull firmly to
remove.
3. Remove belt from turbine pulley (F).
Replace with new belt.
Edge
groomer
replacement
When
to replace
The edge groomers, located on both
sides of the front of the cleaner, should
be replaced when they appear worn.
What
to buy
When purchasing
edge groomers, ask
for HOOVER part No. 39511004.
\
\
12
Replacing
edge
groomers
Disconnect
cleaner
from electrical
outlet.
Warning
- Brush
roll can start sud-
denly,
Unplug
cleaner
when
it is
turned
over.
Remove bottom plate as described
in
Fig. 3-9.
Lift off both old edge groomers and slide
new edge groomers into position as
shown.
Reposition bottom plate and secure with
4 Phillips head screws (Fig. 3-13).
Lubrication
The motor is equipped
with bearings that
contain sufficient lubrication for the life of
the motor. The addition of lubricant
could cause damage.
Therefore,
do
not add lubricant to motor bearings.
The agitator is equipped with two bail
bearings that should be lubricated peri-
odically by a Hoover Factory Service
Center or an Authorized
Hoover Warranty
Service Dealer (Depot).
Thermal
protector
An internal thermal protector has been
designed
into your cleaner to protect it
from overheating.
When the thermal protector activates,
the cleaner will stop running. If this
happens, proceed as follows:
1. Turn the cleaner OFF and discon-
nect it from the electrical outlet.
2. Check secondary and final filters
for dirt accumulation.
3. Refer to "Clearing blockages"
sec-
tion.
4. When cleaner is unplugged and
the motor cools for 30 minutes, the
thermal protector automatically
resets
and cleaning may continue.
If the thermal protector continues to
activate after following the above steps,
your cleaner may need servicing (see
"Service" section).
Publicité
