Publicité
Les langues disponibles
Les langues disponibles
Carrying
cleaner
The cleaner can be moved by using
the earrying handle located on the baek
of the ¢leaneK
Handle
positions
The handle of your cleaner has three
positions; upright
for storage and when
using cleaning tools; operating
posi-
tion for general operation on carpet
and floors; low for reaching under low
furniture.
Step on handle release lever to lower
handle.
A
Embedded
Dirt
FINDER"
feature
(some models)
With red and green lights (A), the 'Dirt
FINDER' system alerts the user to areas
of carpet that may need more cleaning
attention. It is able to sense when larger
amounts of dirt particles, especially
embedded
dirt, are removed.
To let you know that the 'Dirt FINDER'
feature is ready the red light will come on
when the cleaner is first turned on. After
a few seconds, the red light will go off
and the green light will come on.
Cleaning
may then begin.
The green light will remain on through-
out cleaning except when the detector
senses that a larger amount of dirt is
being picked up; then the red light will
come on.
(Fig. 2-7 continued)
When the red light is on, you should
take additional
cleaning strokes
in the
area until it changes to green.
• The red light may seldom come on
during cleaning.
This means that your
cleaner is picking up primarily fine sur-
face dust and lint which the system may
not detect, or that the carpet is general-
ly clean.
To increase
the feature's sen-
sitivity
to dirt, set the switch (B) to the
"Hi" position.
"At other times, the red light may stay
on for a considerable
amount of time.
This means that the carpet contains a
high level of dirt which is being
removed by the cleanen
To decrease
the feature's sensitivity
to dirt, set the
switch to the "Reg."
(Regular) position.
Carpet
height
adjustment
When it is necessary to raise and lower
the front of the cleaner for various car-
pet pile heights, slide the carpet height
control
(C) to the desired setting.
For maximum cleaning performance,
the following carpet height settings are
recommended:
• Low setting:
for all types of carpet
• Higher settings:
for very deep pile
carpet where easier pushing effort is
desired, while maintaining good clean-
ing performance.
Note: If the cleaner is difficult to push,
slide control to the next higher setting.
For ease in sliding knob, place handle in
the upright position and tilt cleaner for-
ward.
BRUSH
ROLL
ON
OFF
CARPET
HARD
Brush
roll control
Note: When handle is in upright
position, brush roll is automatically
OFF.
Move the brush roll control only when
the handle is in the upright position.
Slide control to "Carpet" to turn brush
roll ON for cleaning carpet or rugs.
Slide control to "Hard" to turn brush roll
OFF when cleaning bare fleers.
For ease in sliding knob, place handle
in the upright position and tilt cleaner
forward.
Publicité
