Anker Nebula Capsule Manuel Du Propriétaire page 6

Les langues disponibles

Getting Started

Placement

Place this device on a surface table, flat table in

front of the projection surface. For best results, the

projection surface should be white and flat. The

distance between this device and the projection

surface must be a minimum of 0.58 meters (23") and

a maximum of 3.08 meters (121") to get a projection

image from 20 to 100 inches.

• It is unnecessar y to tilt it towards the

projection surface. You can correct the

projection image with the built-in keystone

correction.

• The distance between the device and the

projection surface determines the projection

image size. For the best result, set the

projection image ranging from 40 to 80 inches.

All manuals and user guides at all-guides.com

• positioning the

Preparing the Remote Control

① For first time use, remove the protective tab to

activate the remote control battery.

② To replace the battery, unlock and open the battery

compartment, insert a new battery positioning the

polarity (+/-) as indicated, and then close and lock the

battery compartment.

Get Started

① Fully charge the built-in battery before using for the

first time by using the provided cable and charger.

② Hold

for 2 seconds on the projector to power

on.

③ Turn the device towards a suitable projection

surface or wall.

④ Rotate the focus by adjusting knob to get the best

focus.

⑤ For first time use, follow the on-screen instructions

to complete the basic settings.

To give your Nebula Capsule the fastest, safest

charge, use the supplied charger only.