• Do not hang or even lean the appliance against any walls.
• Place the fan heater far from any other source of heat, from flammable material (curtains,
tapestries, etc.), from flammable gases or explosive objects (spray cans) and from materials
that can be deformed by heat. Make sure there is 120 cm of free space in front of the fan
heater and 50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on shelves),
level (since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
First use: run the appliance to eliminate the "new smell" and any oil residue from the
manufacturing process for at least 10/15 minutes. During this operation, ventilate the room
well to eliminate the "new smell" that is given off by the appliance.
The fan heater is equipped with the following adjustment devices:
The appliance comes with a thermostat, selector switch, indicator light, 24-hour timer and
safety device:
- the selector switch (A) controls the following:
"0" = off; "
"= fan on; "I"= hot air (1000W); "I I"= very hot air (2000W)
- the thermostat (B) adjusts the ambient temperature, and is greater when the selector is
turned towards the maximum position (clockwise direction): once the temperature has
been reached, it will be kept constant, while setting it to the lines in between causes the
element to come on at intervals.
- The indicator light (C) turns on and off when the appliance reaches the set temperatures.
- safety device: when included it stops operation in the event of overheating. To restore
operation, remove the plug from the mains and wait for it to cool (about 20 minutes) and
insert the plug into the plug point and turn on again.
- switch (D): when the index is in position "I" the
appliance works, but the timer is excluded, in
position "
" the timer is active, in pos."0" the
appliance is off.
24H timer (E): allows to adjust during the 24
-
hours, "on" and "off" periods of the fan heater,
and to repeat them systematically every day; it
is active when the switch (D) located below is in
correspondence with the symbol"
using the timer, first:
a)
Set the correct time: turn the timer disc in the direction of the arrow,
matching the correct time to the reference marker.
b)
The on/off functions are adjustable using the sliders on the disc: when
pushed to the centre, the appliance stays off, when pushed towards the outer
edge of the disc, it turns on; slide the slider button to position it in either
position (1 slider corresponds to 30 minutes).Adjust the position of the
sliders for the times of the day when the appliance must be on (slider to the
".When
13