Kohler K-176 Mode D'emploi page 7

3-11/16"
(9.4 cm)
1/4" (6 mm)
34"
(86.4 cm)
10"
(25.4 cm)
2. Prepare the Site
NOTE: Allow for a 1/4" (6 mm) overlap for the lip of the wall sleeve and a minimum clearance of 1/2"
(1.3 cm) around the back of the opening to enable the clips to fully engage.
Refer to the rough-in information. With a pencil, mark the cut lines onto the finished wall.
Carefully cut out the opening in the finished wall following the penciled guidelines.
For thin finished wall materials of less than 3/16" (5 mm), shim around the back of the opening to
provide adequate support for mounting the interface wall sleeve.
Kohler Co.
7-11/16"
(19.5 cm)
Cutout
Interface Lip
Digital Interface
7
Shim
Wall
Clamp Arm
3/16" (5 mm) Min –
2" (5.1 cm) Max Depth
Shim thin walls if necessary.
1/2" (1.3 cm) Min
Clamp Arm
Clearance
1093343-2-B