Publicité
Les langues disponibles
Les langues disponibles
Operation
! NOTE: The unit can be oper-
ated in Heat Only Mode. When
the unit is only running with the
heater, the
temperature will continuously
be displayed on the On Screen
Display.
! NOTE: The heater may emit
a slight, harmless odor when first
used. This odor is a normal con-
dition caused by initial heating of
internal heater parts and will not
occur again.
D & E.
Thermostat Controls
Adjusts the temperature set point
to your individual requirements.
Once the desired set temperature
is reached the heater will turn off.
The heater will cycle on and off
to maintain the desired set tem-
perature. The default temperature
setting is 72°F (22°C).
→ Adjusted by pressing the
to decrease the setpoint and the
to increase the setpoint on the
remote.
• The On Screen Display will in-
dicate the temperature setpoint
as it is adjusted.
! NOTE: Holding the
down on the unit will change the
10
icon and the intake
button
temperature from °C to °F, or vice
versa.
Disable Heat
If desired, depending on the sea-
son, the heater on the unit can be
disabled. The unit will operate in
the same fashion, with remainder
of the controls.
Pressing the
on the unit at the same time and
holding for 2 seconds will disable
and enable the heater.
! NOTE: When the heater has
been disabled and either the
or the
Screen Display will indicate "--".
F.
Sleep Timer
The Sleep Timer can be set to
automatically shut off the fireplace
after a preset time (from 30 min-
utes to 8 hours).
→ To set the timer press the timer
button on either the remote or the
unit, repeatedly, until the desired
time is displayed.
• The On Screen Display will
display the different times as it
is adjusted. Once the timer has
begun, pressing the
will display the time remaining
before the unit turns Off.
and
buttons
is pressed the On
button
www.dimplex.com
Publicité
