Publicité
Bulb Socket Assembly
Casquillo portalámparas
Assemblage de la lampe
+
Felt Packing
Empaquetadura
de fieltro
Cale en feutre
Motor Shaft
Eje del motor
Arbre d'entraînement
du moteur
Replacing Headlight Bulb
Replacing Belt
+
+
Lift Agitator Up
Unidad del agitador
Soulever l'agitateur
+
Install
New Belt
Instalación
de la correa
Poser la
nouvelle
courroie
➢ ➢ Remove lower plate.
➢ ➢ Grasp the bulb socket and pull
upward while moving it back and forth.
➢ ➢ Remove old bulb by pushing in while
turning counter-clockwise.
➢ ➢ Replace bulb by pushing in while
turning clockwise.
➢ ➢ Only use a bulb rated 130 Volts AC-15
Watts or less.
➢ ➢ Reinstall bulb socket into nozzle
housing by pushing it back down into
slot.
➢ ➢ Reinstall lower plate.
➢ ➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ ➢ Place carpet-bare floor selector in
CARPET position.
➢ ➢ Remove lower plate.
➢ ➢ Remove agitator by carefully lifting
out.
➢ ➢ Remove worn or broken belt.
➢ ➢ Clean agitator.
➢ ➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and agitator
pulley; see illustration for correct belt
routing.
- 28 -
Publicité
