Publicité
Les langues disponibles
Les langues disponibles
Location of Controls and Operation
Control panel
1
Main switch ON/OFF.
Flame brightness setting: L0, L1, L2, L3, L4, five brightness cycle adjustments.
2
Temperature down setting.
3
Temperature up setting.
4
5
Heating setting: Heat power 700W and 1400W.
6
Power switch ON/OF.
Timer: Timing 1-12 hours.
7
USE
The device can be operated either via the controls on the device or by means of the remote
control.
1. Turn on the main switch① of the fireplace to enter standby mode, and the display screen
will display the current temperature.
2. Press the power switch button⑥ to turn on the fireplace.
3. Press the heating button to switch power⑤, with high power displaying HI (1400W) and
low power displaying LO (700W)
4. Press the temperature setting button③④ to adjust the temperature, with a temperature
setting range of 59-95 °F. Press the up button to increase the temperature, and press
the down button to decrease the temperature. The default temperature is 77 °F.
5. Press the flame brightness button② to set the flame brightness:L0-L1-L2-L3-L4, L4-
brightest, L0- turn off the flame.
6. Press the timer button⑦ to set the timer function, 01-12 hours.
Remote Operation
● The standby switch located at the front right hand side above the fire must be first switch
on.
● It takes some time for the receiver to respond to the transmitter. Do not PRESS the
buttons more than once within two seconds for correct operation.
Romote control
17
Publicité
