Publicité
Les langues disponibles
Les langues disponibles
6. Disconnect
wire harness on top of
refrigerator
door top Mnge.
• Release two-pin
connector
by
pressing junction
point with a
fiat blade screwdriver
or
fingernail.
• Green
ground
wire remains
attact_ed to the hinge,
Z Unscrew ._i" hex head screws from
top hinge to remove hinge and
retain for later use.
8. Remove Phillips screws to remove
right and left hinges and retain aii
screws for later use.
9. Remove both stabilizing
brackets with :_," hex head
ddver and retain screws for
later use.
Pullout Freezer Drawer
To prevent accidental
cMId entrapment
or
suffocation
risk, do not remove the divider in the
top freezer basket.
To avoid electrical
shock, whicil can cause severe
personal injury or death, disconnect
power to
refrigerator
before removing doors. After repfacing
doors_ connect power.
To avoid possible injury, product, or" prope_y
damage, you will need two people to perform the
following
instructions.
Materials
Needed:
, Phillips screwdriver
To Remove:
t. Pull drawer open to full
extension.
2. Tilt the lower basket
fop_Jard and lift to remove.
3. Lift top of drawer front to
unhook the drawer from
the slides. Lift door front
out to remove.
To Install:
1. Pu!I both rai!s out to
full extension,
2. While supporting
door front, I_ook
suppo_s
into slots
located on inside of
each slide.
I NOte;
All four drawel
bracket supports
must be in
the proper slots for the drawer to function
properly,
3. Lower door front into final position,
4. Tilt the lower basket
front down and set it
down into tile basket
cradles.
Publicité
