Publicité
Les langues disponibles
Les langues disponibles
with Pull Ring
8.10 REPLACING THE SCRAPER BAR
Scraper Bar
Over time the scraper bar will gradually wear and need replacement.
1.
Place the unit on a level surface, turn the fuel shut-off valve to CLOSED,
and remove the POWER key.
2.
Loosen the retaining nuts and bolts and remove the scraper bar.
3.
Align the holes in the new scraper bar with the holes in the auger housing.
4.
Install the retaining nuts and bolts, tighten them securely.
5.
Check the clearance between the scraper bar and the surface.
6.
Adjust the skid shoes, if necessary, to maintain ground clearance for the
type of surface being cleared. See Adjusting the Skid Shoe Height.
53
BS7680
Publicité
