Step 5: Attach the Upper Handlebar Assembly
NOTE: You will use the black Connector Knobs and Bolts to
connect the Upper and Lower Handlebars together.
1.
Remove the black Connector Knobs and Connector Bolts
from the NEUTON Product Pack included with your
Mower.
Let the Upper Handlebar Assembly lean on the
ground during this process (Figure 5). It is easier to
TIP
start with the Upper Assembly in this position, so
you don't have to hold and balance it while
connecting the sections.
2. Line up the holes of the Upper Handlebar Assembly with
the holes in the Lower Handlebar.
NOTE: There are three (3) height positions (holes in the Upper
Handlebar) for the Upper Handlebar Assembly. Connect the
Upper and Lower Handlebars together using the
appropriate holes at a height that is most comfortable for
you.
3.
Slide the Connector Bolts (from the inside of the Handlebars,
outward) through the predetermined holes in the Upper and
Lower Handlebars on each side of the Mower and lightly
screw on the black Connector Knobs just enough to hold the
Upper and Lower Handlebar sections together (Figure 5).
4.
Swing the Upper Handlebar Assembly into an upright position
so that the Upper and Lower Handlebars line up and slide into
place (Figure 6). Tighten the black Connector Knobs by hand
until they are snug.
5.
Check the length of the Handlebar for comfort. If necessary,
reconnect the Upper and Lower (up or down) to a height that is
best for you.
6.
Position the Main Cable along the Handlebars (Figure 6) and
secure it in place by holding the two (2) Main Cable Retainers in
place while stretching the rubber strap around the Cable, and
securing it into the Hook on the Retainer (Figure 7).
Figure 7
NEUTON CE5.4 Battery-Powered Mower -
All manuals and user guides at all-guides.com
Main Cable
Retainers in place
Safety & Operating Instructions
Black
Connector
Knob
Bolts
Figure 5
Main Cable
Main
Cable
Retainer
Figure 6
Lower
Handlebar
Black
Connector
Knob
Upper
Handlebar
Black
Connector
Knobs
Main
Cable
Retainer
7