Publicité
Les langues disponibles
Les langues disponibles
Step 3: Charge the Battery before your first use.
Use the NEUTON 24V Charger only with the NEUTON 24V Battery. Use of other Chargers or the NEUTON 24V Charger
with other Batteries may result in bursting of the Battery, which could cause personal injury and property damage.
You MUST charge the Battery for eight (8) to fourteen (14) hours before you use the Mower for the first time. If you do not
charge it before using the Mower, the Battery's charging capacity may decrease.
NOTE: Always charge the Battery while it is out of the Mower.
1.
Remove the Protective Plug from the Charger Receptacle on the Battery and
plug in the round Charger Connector (Figure 3).
2.
Plug the Charger into a standard 110V wall outlet. The RED light on the
Battery will light up indicating a connection between the Battery and the
Charger and the RED light on the Charger will light indicating that the Battery
is charging.
3. Once charging is complete, the LED on the Charger will change from RED to
GREEN and the RED LED on the Battery will turn OFF indicating that the
Battery is fully charged and is ready for use.
NOTE: For the first five (5) hours, the Charger will be warm to the touch. This is
normal and does not indicate a problem.
Step 4: Attach the Lower Handlebar
To keep the Mower from moving while you assemble it, place your foot behind one of the wheels.
TIP
NOTE: You will use the green Quick-Connect Knobs to attach the Lower Handlebar to the Mower.
1. Set the Cutting Height Lever (Figure 4) to the highest adjustment (position 6 – Lever all the way down). This makes it
easier to reach the slots on the Mower frame.
Cutting Height Lever
(Adjust all the way down.)
Green Quick-Connect Knob
2.
Position the Lower Handlebar with the smooth side against the frame of the Mower. Slide it down fully into the slot on the
frame until the holes line up (Figure 4).
NOTE: Be sure you slide the Handlebar all the way down to the bottom of the slot. When you do this, the cutout notch on the end of
the Handlebar aligns with the base of the channel in the Mower's frame.
3.
Insert a green Quick-Connect Knob with a Lock Washer through the lined-up holes on the Handlebar and Mower Frame.
Turn the Knob clockwise until firmly snug. Repeat this step for the other side.
Be sure to tighten the green Quick-Connect Knobs by hand. Do not use a tool to tighten them; you could easily over tighten
them and damage the parts.
6
All manuals and user guides at all-guides.com
Lock Washer
Figure 4
Battery Charger
Figure 3
Lower Handlebar
Holes aligned
www.neutonpower.com
Protective
Plug
Publicité
