Publicité
Les langues disponibles
Les langues disponibles
Installing the Bagger
1.
Raise the Discharge Guard on your Mower (Figure 12) and
note the metal Support Rod at the rear of the Mower.
2.
Grasp the Bagger by the Top Handle and center it at the
back of the Mower.
3. Align the Metal Latch Hooks (Figure 13) over the Support
Rod and lower the Bagger in place until the Wire Frame at
the bottom of the Bagger rests on the Mower.
4.
Lower the Discharge Guard.
Removing and Emptying the Bagger
1.
Raise the Discharge Guard.
2.
Using the Top Handle of the Bagger, lift the Bagger off the
Support Rod and away from the Mower.
3.
Lower the Discharge Guard.
4.
To empty the Bagger, tilt the Top Handle forward. Use the
Cloth Handle (Figure 14) at the rear of the Bagger to move
the contents toward the front as you empty the Bagger.
Step 7: Insert the Battery after being fully charged.
1.
Orient the Battery with the indentations on the bottom of
the Battery lining up with the metal tabs in the bottom of
the Battery compartment.
2.
After confirming the correct orientation of the Battery, insert
the Battery fully into the Battery compartment.
3.
Turn the Battery Retainer Arm back over on top of the
Battery to secure it in place (Figure 2 on page 5).
NOTE: If the Battery is not oriented correctly, it will not fully depress
into the opening. If this happens, remove the Battery,
recheck the orientation, and try again.
NEUTON CE5.4 Battery-Powered Mower -
All manuals and user guides at all-guides.com
Safety & Operating Instructions
Discharge Guard
Support
Rod
Figure 12
Latch Hook
Support
Rod
Figure 13
Figure 14
Cloth Handle
9
Publicité
