Trust PREMIUM-LINE ZWLD-100 Mode D'emploi page 4

EN
ZWLD-100 WATERLEAKAGE DETECTOR
COMPATIBILITY
The water leakage detector works with the Smart Bridge and the ICS-2000 to receive push notifications when water is
detected. NOTE: For receiving push notifications, a fully working internet connection is required.
1. (RE)PLACE THE BATTERIES
A
Remove the battery cover (backplate) by sliding it from the water leakage detector.
B
Place 2x AAA batteries (not included) in the detector. Note the positive and negative polarity in the compartment. Close
the battery cover.
2. DOWNLOAD APP
To connect the detector with a Smart Bridge or ICS-2000, first get the App by scanning the QR code or go to trust.com/
zigbee and install it.
3. CONNECT DETECTOR
A
In the App, select a room,
press the + button and choose Trust Zigbee line/Water leakage detector and follow the instructions. For manual set up of
push-notifications go to the rules tab, press the + button and select notification wizard.
4. INDICATORS
The detector contains a LED indicator to show the status of the detector.
LED FUNCTION TABLE
Connection mode
Connected successfully
Water detected
Detector reset
4
LED will flash fast for approximately 1 min.
LED will light up for 3 sec (The App will also
indicate when the connection is successful)
Red LED will light up once (The App will also
indicate when water is detected)
LED will flash 6x