Publicité
Les langues disponibles
Les langues disponibles
8 - INSTALLATION INFORMATION AND INSTRUCTIONS
FOR DRAIN COUPLING, DRAIN-BOA
Thoroughly wet coupling in water before folding ends
back and before installing over pipes ends (A) and (B)
as shown in Fig. 2
(5.46cm)
About 0.70"
(1.78cm)
(4) ribs for
sealing at
each end
This inlet port
designed to receive
3/8" or 1/2" drain
tubing from upstream
air gap on top of sink
(Ref. Fig.8)
Drain-BOA™ Rubber Coupling folded back on itself
at each end and ready to be installed in the kitchen
sink tailpiece
(Measures just over 2.125" when fully folded
back as shown).
Use "water
pump style"
pliers with
nylon snap
clamps and
tighten 3 or 4
clicks beyond
hand tight
Stainless
screwdrive
clamps not
furnished. They
can be
purchased
commercially if
owner desires.
After installation then center coupling over cuts
(A) and (B) by working it back and forth.
Typical view of (Fig.2) plastic tailpiece after installing
the Drain-BOA™ Rubber Coupling
(Polyethylene drain tubing from air gap properly
inserted to inner stop and clamped). (Note: Wet tubing
only with water before installation).
All manuals and user guides at all-guides.com
2.15"
Note
When properly
centered then
all four ribs
should be
resting over
pipe ends (A)
and (B).
1.975"
(5cm)
When istalling (and
if necessary) slight
bending of port is
acceptable.
Fig. 1
Plastic "snap clamps"
depicted (3) places are
furnished with each
coupling. (Clamps
reusable many times if
removed and installed
carefully).
Clamps
N700 for 3/8" tube
N800 for 1/2" tube
Port accepts 3/8"
and 1/2" poly tubing
Fig.3
87
TM
MODEL DC9700
1.50" (3.8cm) dia.
Can be metal
We suggest
or plastic
make cut (A)
first
Cut should
Cut (A)
be straight
Cut (B)
(C)
2"
Trap
Fig.2
Typical view under kitchen sink with 1.5" dia.
plastic tailpiece and sink trap.
(Use very fine teeth hacksaw blade, recommend
32 teeth per inch. Use folded coupling as a template
to mark tailpiece for cuts (A) and (B). Discard item (C).
May be brass and
may be chrome
plated. Plastic is
common also.
Cut (B)
2"
During installation, can
swivel trap to this position
if desired.
Fig.4
Depicts metal 1.5" kitchen sink tailpiece
with Drain-BOA™ properly installed.
(Solid plug depicted here in lieu of the typical 3/8" O.D.
Polyethylene tubing as if the "R.O." system has been
removed). Solid plug (97002) must be installed at all
times when tubing is not installed.
(97002) Special
design plug.
Always keep plug
for use when no
tubing is installed.
(This custom plug
also included with
each coupling).
Inlet port
Trap top nut
With trap swiveled,
no need to fold
lower end of
coupling to install.
With the coupling
centered then
rotate so that inlet
port is pointed in
the optimum
direction
Publicité
