gala gar Smart 150 MMA battery Manuel D'instructions page 13

2. ACCESORIES.
REFERENCE
259040
22300150BT11
22300150BT27
M-22300150BT_V1
GALA GAR has a complete range of welding accessories where you can find those most
suited to your needs.
USE ONLY THE RECOMMENDED SPARE PARTS AND ACCESSORIES.
3. TRANSPORT AND INSTALLATION.
3.1 . TRANSPORT AND PACKAGIN.
Knocks and sudden movements must be avoided when transporting the equipment. In any case, the packaging
must be protected from water.
HANDLE THE EQUIPMENT CAREFULLY, IT WILL LAST LONGER !
3.2. ELECTRICAL SUPPLY INSTALLATION
When a long output cable is used, in order to reduce the voltage drop, the cable with a larger section area is
recommended; if the cable is too long, it will have great impacts on the arcing performance, or even other
performance of the system.
•
Input connecting cable
This welder is a cordless li-ion battery welder, which can be used for welding without AC.
•
Output connecting cable
Insert the quick plug of the electrode holder cable into the positive welding connector "+", tighten it tightly in a
clockwise direction. Connect the ground clamp to the negative "-" weld connector in the same way. The ground
clamp should grip the workpiece or welding table.
3.3 BATTERY CHARGE CYLCE.
To charge the battery, connect the charger to the battery charge connector (L) and to the mains. The charger will
start the charge cycle whenever it detects that the battery is not at its maximum level. During charging, several red
LEDs light up on the charger grids. When the battery is full, the cycle ends, and only the green LEDs light up on the
charger.
Normally we recommend charging the battery with the machine off. But, if necessary, the equipment can charge and
weld at the same time, as long as the battery is not at the minimum level. In this last case, the low battery voltage
indicator (K) will light up when trying to weld. Note that the charging time will increase, or even drain the battery on
average, depending on the duty cycle of the weld.
To find out the current charge level of the battery, turn on the main switch of the equipment (M) and press the button
of the battery charge meter (E). The battery charge level indicator (D) will activate, showing the percentage of charge
available.
Smart 150 MMA battery
STANDARD EQIPMENT
Grounding and
Electrode clamp
Lithium battery.
Battery charger.
Instructions manual.
REFERENCE RECOMMENDED
23301632PQ Electrodes 3.25 mm.
5998E Electronic welding helmet.
13