Motorola PMPN4563 Mode D'emploi page 9

Figure 2: Charging Radio
Procedure:
1 Firmly insert the power supply into the charger DC Inlet Socket at the back of the charger.
2 Plug the power supply power cord into a matching power outlet.
Upon successful power-up, each pocket LED shows Green for one second.
NOTE: Check the power cord connections if the LEDs do not flash and no message is
displayed.
3 Insert the radio with battery or stand-alone battery into an available pocket.
When the radio or stand-alone battery is properly inserted into the pocket, the charging status is
indicated as the followings:
• Radio - Radio Display
• Stand-alone battery - LED status indicator of the associated pocket on the MUC.
NOTE: The radio or stand-alone battery is ready for use when the LED is Steady Green.
Figure 3: Charging Stand-alone Battery
2.2
Charging Indicators
LED indications are associated with charger software version 1.05 and above.
MN007796A01-AC
Chapter 2 : Charger Overview
9