Publicité
Les langues disponibles
Les langues disponibles
Moving care
geinsta{Eng the dryer
For power
supply
cord-connected
dryers:
1.
Unplug
the power
supply
cord.
2.
Make sure leveling
legs are secure in dryer base.
3.
Use masking
tape to secure dryer door.
For direct-wired
dryers:
Electrical Shock Hazard
Disconnect
power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
Follow
the "Installation
Instructions"
to locate,
level, and connect
the dryer.
The dryer light automatically
turns on inside the dryer drum when
you open the door.
1.
Disconnect
power.
2.
Disconnect
wiring.
3.
Make sure leveling
legs are secure in dryer base.
4.
Use masking
tape to secure dryer door.
To change
the drum
might
1.
Unplug
dryer or disconnect
power.
2.
Open the dryer door. Locate the light bulb cover on the back
wall of the dryer. Using a Phillips
head screw driver,
remove
the screw
located
in the lower right-hand
corner of the cover.
Remove
the cover.
3.
Turn bulb counterclockwise.
Replace the bulb with
a 1 O-watt appliance
bulb only. Replace the cover and secure
with the screw.
4.
Plug in dryer or reconnect
power.
TROUBLESHOOTING
First try the solutions
suggested
here or visit our website
and reference
FAQs (Frequently
Asked Questions)
to possibly
avoid the cost of a service
call...
In U.S.A. http://www.maytag.com/he{p
- In Canada
www.maytag.ca
Dryer
will
not run
[]
}s the dryer door firmly
closed?
[]
Was the Start button
firmly
pressed?
Large loads may require pressing
and holding
the Start button
for 2-5 seconds.
[]
[]
Has a household
fuse blown,
or has a circuit
breaker
tripped?
There may be 2 household
fuses or circuit
breakers
for the
dryer. Check that both fuses are intact and tight, or that both
circuit
breakers
have not tripped.
Replace the fuse or reset the
circuit
breaker.
If the problem
continues,
ca[[ an electrician.
Is the correct
power
supply
available?
Electric
dryers require
240-volt
power
supply. Check with
a
qualified
electrician.
[]
[]
Is coin, button,
or paper clip caught
between
the drum and
front
or rear of the dryer?
Check the front and rear edges of the drum
for small objects.
Clean out pockets
before laundering.
Are the four legs installed,
and is the dryer
level front to back
and side to side?
The dryer may vibrate
if not properly
installed.
See the
Installation
Instructions.
[]
[s the clothing
knotted
or balled
up?
When
balled
up, the load will
bounce,
causing the dryer to
vibrate.
Separate the load items and restart the dryer.
No heat
[]
Has a househo{d
fuse blown,
or has a circuit
breaker
tripped?
The drum may be turning,
but you may not have heat. Electric
dryers use 2 household
fuses or circuit
breakers.
Replace the
fuse or reset the circuit
breaker.
[f the problem
continues,
ca[[
an electrician.
Dryer
disp{aying
error
message
(WET
indicator
flashing)
[]
WET indicator
is flashing:
If the WET indicator
on the dryer control
panel is flashing,
with a pause between
flashes,the
dryer control
has detected
a
problem
that requires
service.
Ca[[ for service.
Publicité
