Vaporesso LUXE Q2 Mode D'emploi page 5

ENGLISH
USER INSTRUCTIONS
1. Install & Replace the Pod
Pull out the pod from the battery and
install the new one.
*If it's the first time using the device,
please tear off the sticker of the pre-
installed pod.
2. Fill the E-liquid (Refer to FIGURE 1)
3ML :
Pull out the silicon plug then squeeze
the e-liquid through the filling slot. After
filling, put the silicon plug back and make
sure it's shut firmly.
2ML :
Snap off the mouthpiece then squeeze
the e-liquid through filling slot. After
filling, put the mouthpiece back and
make sure it's shut firmly.
*If it's the first time filling the e-liquid,
please wait 5 minutes for the coil to
prime.
3. Adjust the Airflow (Refer to FIGURE 2)
There is an airflow control toggle on the
side of the battery. Adjust the toggle
according to your vaping habits for
different airflow effects.
4. Start Vaping
The device is draw-activated. Inhale
through the mouthpiece and exhale to
start vaping.
5.Check the Battery Level
Battery Level LED Color
70%~100% Green
30%~70% Blue
0~30% Red
6. Charging
Please use the in-box Type-C cable to
charge the device. The LED indicator will
flash in red while charging and stay on
green while fully charged.