Publicité
Les langues disponibles
Les langues disponibles
Hold the machine with a firm grip. High reaction torque can briefly occur while driving
in and loosening screws.
Secure the workpiece. A workpiece clamped with clamping devices or in a vice is held
more secure than by hand.
Keep your workplace clean. Blends of materials are particularly dangerous. Dust from
light alloys can burn or explode.
Always wait until the machine has come to a complete stop before placing it down.
The tool insert can jam and lead to loss of control over the power tool.
Avoid unintentional switching on. Ensure the trigger is in the off position before
inserting battery pack. Carrying the power tool with your finger on the trigger or
inserting the battery pack into power tools that have the switch on invites accidents.
Safety Warnings for battery chargers
For indoor use only.
Keep the battery charger away from rain or moisture. Penetration of water in the
battery charger increases the risk of an electric shock.
Do not charge other batteries. The battery charger is suitable only for charging the
batteries that were supplied with your power tool. Otherwise there is danger of fire and
explosion.
Keep the battery charger clean. Contamination can lead to danger of an electric shock.
Before each use, check the battery charger, cable and plug. If damage is detected,
do not use the battery charger. Never open the battery charger yourself. Have
repairs performed only by a qualified technician. Damaged battery chargers, cables
and plugs increase the risk of an electric shock.
Do not operate the battery charger on easily inflammable surfaces (e. g., paper,
textiles, etc.) or surroundings. The heating of the battery charger during the charging
process can pose a fire hazard.
Children should be supervised to ensure that they do not play with the battery
charger.
VIBRATION AND NOISE INFORMATION
Vibration and noise level
The vibration and noise emission level stated in this instruction manual has been
measured in accordance with a standardised test in EN 62841. It may be used to compare
8
Publicité
