Publicité
Les langues disponibles
Les langues disponibles
SECTION 6: HOW TO SET THE THERMOSTAT
Normally, the display shows the temperature detected by the temperature sensor. If the temperature
sensor is not plugged in or damaged, the display shows 00.
1. Press and hold the left key (WORK/+) for 3 seconds to enter WORK temperature setting. The
temperature on display screen flashes. Now the left key (WORK/+) is the for increasing the
temperature and the right key (STOP/-) is the for decreasing the temperature, you may change the
temperature by pushing these 2 buttons, after setting, stop for 3 seconds and do not operate any
button. The temperature will be saved and exit the setting interface to return to the actual
temperature interface of the temperature sensor. (Note: the initial WORK temperature is 32 ℃.
When the temperature sensed by the temperature sensor is
the WORK mode and the fan will start running.)
2. Press and hold the right key (STOP/-) for 3 seconds to enter STOP temperature setting, and the
temperature on display screen flashes. Now the left key (WORK/+) is the for increasing the
temperature and the right key (STOP/-) is the for decreasing the temperature, you may change the
temperature by pushing these 2 buttons. After setting, stop for 3 seconds without any operation
on the buttons, the temperature will be saved and exit the setting interface, and display the current
temperature detected by sensor. (Note: the initial STOP temperature is 23 ℃. When the
temperature detected by the temperature sensor is below 23 ℃, the thermostat will enter the
STOP state and the fan will stop working.)
3. The working temperature of the thermostat is between 0-60 ℃. (Notice: if there is no temperature
sensor or it is not working, the thermostat defaults to WORK status, that is, the fan works. If the
temperature is between 23-32 ℃ for the first use, the thermostat defaults to STOP status, that is,
the fan does not rotate.)
4. The WORK temperature set has to be higher than the STOP temperature. (i.e. when the WORK
temperature is set to 30°C, the STOP temperature can be set to 29°C maximum.)
5. Reset: hold both buttons of WORK and STOP for 3 seconds, the screen displays 88°C+WORK+STOP
and flashes for 3 times, and then exit to display the current temperature or display 00 if no
temperature is detected. The product is reset to default setting.
SECTION 7: HOW TO MAINTAIN THE RADIATOR VENTILATOR
7.1 Cleaning the product
The Radiator Ventilator and matching components can be cleaned if necessary. To clean the product:
1. Clean the product with a vacuum cleaner, when dirty. CAUTION! Make sure to use the lowest power
setting on the vacuum cleaner.
2. Clean the product with a damp cloth only if required. CAUTION! Make sure no water enters the
Radiator Ventilator through the fans.
7.2. Replacing components
If any components break, they must be replaced. CAUTION! Do not attempt to open, modify or repair
the product. To replace components:
1. Exchange broken components, still under warranty, at the supplier. The Radiator Ventilator has a
ten year guarantee and the power adapter has a 2 year warranty. NOTICE For safety- and control
reasons (CE), alterations or modifications of this product are not permitted.
2. Dispose of broken components that are not under warranty and buy new components.
≥
32 ℃, the thermostat will enter
Publicité
