Suzuki RM250K4 2003 Manuel D'assemblage page 12

All manuals and user guides at all-guides.com
Fit the rubber cover onto the throttle housing.
A: Rubber cover
FRONT BRAKE MASTER CYLINDER
Remove the bolts and holder from the front brake
master cylinder.
A: Master cylinder
B: Holder
C: Bolt
Install the front brake master cylinder onto the han-
dlebars. Align the dot mark on the handlebars with
the master cylinder-to-holder fitting surface. Tighten
the master cylinder mounting bolts to the specified
torque.
A: Master cylinder
B: Bolt
C: Bolt
!
A: Bolt
B: Holder
11
" Front brake master cylinder mounting bolt: " " "
NOTE:
To install the holder correctly, first tighten the
bolt B B B B of the upper side with specified torque
and then tighten the bolt C C C C of the lower side.
NOTE:
Install the holder in position according to the
mark "UP".
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.
10 N·m (1.0 kgf-m)
D: Holder
E: Dot mark
C: Master cylinder
D: Handlebars