Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
Item no. 672365 / Version 12/11
RADIO WALL CLOCK SOLAR EFWU 330 S
INTENDED USE
This product is intended for displaying the time, date and temperature.
The time is set automatically using an integrated DCF receiver.
Always observe the safety instructions and all other information included in these
operating instructions.
This product complies with the applicable National and European regulations. All
names of companies and products are the trademarks of the respective owner. All
rights reserved.
PACKAGE CONTENTS
-
Radio Wall Clock
-
Operating Instructions
SAFETY INSTRUCTIONS
Please read all of the operating instructions before using the product
for the fi rst time; they contain important information about the correct
operation. The warranty will be void in the event of damage caused by
failure to observe these safety instructions! We do not assume any li-
ability for any consequential damage!
Nor do we assume any liability for material and personal damage caused
by improper use or non-compliance with the safety instructions! The
warranty will be void in such cases.
-
For safety reasons, any unauthorised conversion and/or modifi cation of the
product is not permitted. Never dismantle the product.
-
The product is intended exclusively for use in dry interiors; it must not get damp
or wet.
-
This product is not a toy and does not belong in the hands of children. Only use
the product out of the reach of children; the product contains parts that can be
swallowed as well as a rechargeable battery.
-
Condensation may form when the product is brought from a cold room into a
warm one. Wait until it has reached room temperature before using it.
-
Do not leave the packaging materials unattended. They may become dangerous
playthings for children.
-
Handle the product with care; it can be damaged by impacts, blows, or accidental
drops, even from a low height.
NOTES ON RECHARGEABLE BATTERIES
-
The product is equipped with a permanently installed rechargeable battery that
doesn't need replacement. Do not open the device to replace the accumulator
or to recharge it. The recharging of the battery takes place via the inbuilt solar
cells.
-
The radio wall clock is supplied with power at night via the rechargeable battery.
No further power supply is necessary. With a fully charged battery, an operating
time of approx. one year is possible even with an operation in total darkness.
-
Batteries/rechargeable batteries must not be short-circuited, opened or thrown
into a fi re. There is a risk of explosion!
INSTALLATION/SETUP
The radio wall clock can stand on an even surface or hang on the wall.
-
For the setup of the device, fold out the two feet (9).
-
For wall mounting there are suspension eyes on the device's rear.
Choose a bright location, ideally close to a window, in order for the solar
cells to get enough light to charge the inbuilt accumulator suffi ciently
and in a fail-safe manner.
For interference-free DCF reception, the radio wall clock should not be
hung or placed close to other electronic devices, cables, metal items,
etc.
All manuals and user guides at all-guides.com
CONTROLS AND PARTS
(1)
Display
(2)
Solar cells
(3)
SET button
(4)
ADJUST button
(5)
°C/°F button
(6)
RESET button
(7)
ON/OFF Switch
(8)
Suspension eyelets
(9)
Feet
INITIAL START UP
-
Switch the clock on using the ON/OFF switch (move switch to ON position).
-
Briefl y after switching the clock on, the fi rst reception attempt for the DCF signal
takes place. The reception symbol appears on the display and after a successful
DCF reception the correct time will be displayed.
-
Reception display:
no reception
bad
Following the establishment of DCF (long wave time signal) reception, the
time will be shown in 12 hour format. If you would like to change the display
into the 24 hour format, then proceed as described in the section on "set-
ting the time manually" and then do a manual DCF reception trial (for this
see the section "doing a DCF reception trial").
-
If no display appears after switching the clock on, press the RESET button (6)
using a sharp item (e.g. the top of a ball-pen).
-
If there is no display afterwards, the inbuilt rechargeable battery is empty.
In that case, switch the clock off (move ON/OFF switch (7) to OFF position) and
expose the clock to bright light. For the required charging times please refer to
the table further down in this operating manual.
Direct sunlight is the best for recharging the accumulator as the solar cells here-
by have their highest effi ciency.
The detection of the DCF signal and its evaluation may take several minutes.
Do not move the radio wall clock during that time. Do not use any buttons!
Bad reception can be caused, for example, by metalized insulated glass, rein-
forced concrete buildings, coated special wallpapers, proximity to electronic
devices, or installation in cellars.
If the correct time is not shown after 10 minutes, change the position of the
radio wall clock and press the RESET key (6).
This will start a new reception attempt.
The reception attempt for the daily automatic synchronisation with the DCF time is
done several times a day. One successful reception per day is suffi cient to keep the
deviation to less than 1 second.
The DCF signal is encoded and transmitted via
a DCF transmitter in Mainfl ingen (near Frank-
furt). Its range is up to 1500 km and, under
ideal reception conditions, even up to 2000 km.
Among other things, the DCF signal includes
the precise time (theoretical deviation of 1 sec-
ond in a million years!) and the date.
This means there is no need for manual set-
ting of summer and winter time.
S O L A R
R A D I O
C O N T R O L L E D
1
MONTH
DATE
DAY
TEMP
3
R E S E T
ON
OFF
SET
ADJUST
°C/°F
4
suffi cient
very good
1500 km
2000 km
2
8
5
6
7
9
Publicité
