Télécharger Imprimer la page

Helvei Smartmove ALLROAD Mode D'emploi page 3

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
SPEED
Maximum speed: 15km/Hours (not recommended to use maximum
speed while driving). Helvei Smartmove Allroad can keep good balance
of driver within prescribed speed, if beyond, will resulting in loss of bal-
ance, personal injury or accident.
UPHILL & DOWNHILL
Helvei Smartmove Allroad could detect the slope while uphill or downhill,
then output torque trough intelligent chip automatically to adjust the
motor, ensure drives safety while driving.
CAUTIONS:
Please drive Helvei Smartmove Allroad with the protection of other one's
help while first time operation, to prevent fall down or lose balance.
All manuals and user guides at all-guides.com
PEDAL SENSORS
Helvei Smartmove Allroad is equipped with four sensors under foot pedal,
it will adjust to equilibrium situation automatically, while stepping on
foot pad.
Do not step beyond foot pad edge, please ensure your foot is right
stand on the pedal while driving.
Don not load any luggage on the pedal, the sensor will keep recog-
nized Helvei Smartmove Allroad power on.
It will increase the probability of collision resulting in injury or damage
to driver or scooter itself.
DISPLAY PANEL
Display panel is located in the middle of Helvei Smartmove Allroad which
be used to display running information.
A power display area: it shows full power when white light turns on
three lattice;
Running display area: when driver stand on the pedal and trigger
sensors, running indicator lights turn on in operation status. If an error
occurred in running system, the indicator lights will be into red light.
Please follow the prompt operation instructions to learn and practice
driving.
To ensure you in comfortable clothes and shoes, and make sure the
flexibility of the body. If necessary, please wear safety equipment while
driving, kind hope you can successfully complete this initial driving
stage.
I-SWEET DRIVING PRACTICE
Step 1. Press the power switch and start Helvei Smartmove Allroad .
Step 2. Ready for driving, one foot step on pedal pad, the indicator
running lights is on, after the foot switch is triggered. Helvei Smartmove
Allroad system into self-balancing condition. Another, foot step on the
other side pedal pad after kept the body balance. Stationary standing
3
USER MANUAL SMART SCOOTER
EN
| Principle of operation

Publicité

loading