Porter & Charles SPPS60TM-1 Manuel D'instructions page 13

Basic settings
Setting the clock
After your microwave oven is first connected or after a power failure, the clock display will flash to
indicate that the time shown is not correct. Before using the microwave oven, adjust the clock through
the procedure described below but starting on Step 3. To set the clock, proceed as follows:
1. Press the "+" key until the Clock Indicator
Light starts to flash.
2. Press the OK key.
3. Press "-" and "+" keys to set the correct hour
value.
Hiding / Displaying the Clock
If the clock display disturbs you, you can hide it by proceeding as follows:
1. To hide the clock press the "+" key and the "-
" key simultaneously for 5 seconds. The
dots that separate the hours and minutes
and the clock symbol will flash, but the rest
of the clock display will be hidden.
4. Press the OK key to validate the hour value.
The minute numbers will start to flash.
5. Press "-" and "+" keys to set the correct
minute value.
6. To finish, press the OK key again.
2. If you want to see the clock display again,
press the "+" and "-" keys again for 5
seconds.
13 | EN