Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
EN
Do not use detergents. It is important to let the wet parts dry
thoroughly. Do not use a hair dryer for drying! Wet filters will be
damaged if used for vacuuming!
4.
Assemble cleaned or new components and install them in the original
location using the reverse procedure.
Note: Wet cleaning can cause more wear and tear of the filter, and
a correspondingly shorter service life. If the vacuum cleaner does not perform
with the original suction power, the filters should be replaced with new ones.
CHECKING AND REPLACING THE AIR OUTLET FILTER
Open the air outlet grid at the rear section of the vacuum cleaner by
1.
turning (see Fig. 8).
Remove the filter by turning (Fig. 9).
2.
3. The filter can be cleaned by tapping or shaking it. If the filter is
extremely dirty, it can be washed in lukewarm water. Let the filter
dry completely before using it again.
4. Insert a cleaned or new air outlet filter, and close the air outlet grid.
CLEANING AND MAINTENANCE
The vacuum cleaner and its accessories can be cleaned with a wet cloth.
Do not immerse the power cord, plug, or appliance in water or any other
liquid.
Do not use aggressive substances for cleaning, such as solvents or abrasives!
TROUBLESHOOTING
Problem
Motor does not run.
Motor has stopped
operating.
Reduced suction power
Vacuum cleaner heats up
48
Cause
Plug inserted into the
mains outlet incorrectly or
insufficiently.
The mains outlet is not live.
Improper or insufficient air
flow. Motor overheating
fuse activated.
Dust bin full or clogged.
The filters are clogged
Clogged nozzle, tube, or
hose.
Slight heating of the vacuum cleaner is normal and cannot be considered
a failure.
Fig. 7
Solution
Check the plug connection.
Check for voltage, e.g. by connecting
another appliance.
Disconnect the cable from the socket.
Check and release the air suction
and discharge holes; check the filter's
cleanliness and/or replace the dust bag.
Let the vacuum cleaner cool down.
Empty and clean the dust bin.
Clean or replace the filters.
Check and clear the air passage on the
suction and discharge sides.
Fig. 8
Fig. 9
VP 5 200
Publicité
