Beko WMB 71442 LMA Manuel D'utilisation page 76

Discharging the water when the product has an emergency
draining hose:
a. Pull the emergency draining hose out from its seat
b. Place a large container at the end of the hose. Drain the
water into the container by pulling out the plug at the end
of the hose. When the container is full, block the inlet
of the hose by replacing the plug. After the container is
emptied, repeat the above procedure to drain the water in
the machine completely.
c. When draining of water is finished, close the end by the
plug again and fix the hose in its place.
d. Turn the pump filter to take it out.
Discharging the water when the product does not have an
emergency draining hose:
a. Place a large container in front of the filter to catch water
from the filter.
b. Loosen pump filter (anticlockwise) until water starts to
flow. Fill the flowing water into the container you have
placed in front of the filter. Always keep a piece of cloth
handy to absorb any spilled water.
c. When the water inside the machine is finished, take out
the filter completely by turning it.
4. Clean any residues inside the filter as well as fibers, if
any, around the pump impeller region.
5. Install the filter.
6. If the filter cap is composed of two pieces, close the filter
cap by pressing on the tab. If it is one piece, seat the tabs
in the lower part into their places first, and then press the
upper part to close.
76 / EN
Washing Machine / User's Manual