Publicité
Les langues disponibles
Les langues disponibles
CARE AND MAINTENANCE
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Storage
• When your pressure washing session has been
completed, turn off the power switch located on the
front of the power washer. Unplug the power cord
from the outlet. Turn off the water supply. Pull the
trigger on the spray gun 2-3 times to drain out the
excess water and to release any remaining water
pressure. Disconnect the garden hose adapter from
the water inlet. DO NOT allow the power washer to
run with no water flowing through it.
• Remove detergent bottle and clean completely.
Residual chemical will stick to the container and can
cause the detergent injector to clog and not function
properly.
PUMP SAVER
Pump Saver is a product that protects and prolongs
the life of the pump. This will keep the internal parts
of the pump lubricated and protected from freezing
while being stored in ALL climates. It also assists with
protection from internal corrosion. The Blue Clean part #
is: PW64511 (16oz. bottle). Order online at
www.arblueclean.com
Pump Saver Instructions
Follow the previous storage instructions for your power
washer. To prevent staining, protect the surface under
the power washer from any excess fluid. Wear eye
protection when using this product.
Turn unit off and disconnect all hoses before adding
pump protector. Unscrew threaded top from bottle to
remove seal and reattach threaded top to bottle.
Remove black cap from bottle.
1) Screw garden hose adapter (G) clockwise onto
threaded top of pump saver bottle.
2) To connect, push garden hose adapter (G) and pump
saver bottle firmly into clear quick connect filter (F),
previously installed to pressure washer inlet.
14
All manuals and user guides at all-guides.com
• Remove high pressure hose from spray gun.
• Remove lance from the gun. Place the gun in the holder
on the side. Lances are placed into any of the slots in
the back of the unit. Make sure to discard any remaining
detergent from the bottle. Flush the bottle and nozzle
head with fresh water to prevent clogging.
• Hook the power cord around the L-shaped tabs on the
right side of the machine when facing it.
3) Turn power on. Turn the power washer off as soon as
Note: Instructions on Pump Saver Bottle are generic and
the Pump Saver begins to exit the pump outlet.
not model specific.
F
G
Publicité
