Publicité
Les langues disponibles
Les langues disponibles
CARE AND MAINTENANCE
Detergents
• Use detergents designed for power washers. These
can be purchased online at our website www.
arblueclean.com. Hardware stores or home centers
also have power washer detergents for different
cleaning projects. The cleaning solution should be
the consistency of water in order to prevent clogging
your detergent bottle and nozzle.
• This system applies detergent under low pressure.
The cleaning power of the detergents is enhanced
when applied with low pressure and enough time is
given to break down dirt and grime. The combination
of low pressure and chemical action is very effective
and can be better than scrubbing if applied properly.
ALWAYS spray detergent on a dry surface. DO NOT
pre-soak area. Wetting the surface first dilutes
the detergent and reduces its cleaning ability. DO
NOT allow detergent to dry on surface. On vertical
surfaces being cleaned, apply detergent to lower
surfaces and work your way up to prevent detergent
from causing streaks in the dirt and grime. Rinse
detergent by pressure washing from bottom up for
same reason.
• If a stain is particularly tough, it may be necessary
to reapply the detergent and use a bristled brush to
scrub the stain. Subsequent power washing after
brushing should successfully complete your cleaning
job.
Cleaning Clear Quick Connect
• The screens inside the clear garden hose adapter
should be cleaned periodically. Rinse it with clean
water, and then place it back in the adapter.
All manuals and user guides at all-guides.com
Cleaning Nozzles
• A clogged or partially clogged nozzle can cause
• Turn off the unit.
• Turn off the water supply to the unit.
• Relieve any pressure trapped in the hose by
• Remove the lance from the spray gun
• Using the nozzle tip cleaner provided (or an unfolded
• Tap quick connect end of lance on hard surface
• Back flush water through the nozzles using garden
significant reduction of water pressure coming out
of the nozzle and/or cause the unit to pulsate while
spraying.
squeezing the trigger 2-3 times, and then lock the
spray gun by pushing the lock button from left to
right.
paper clip), insert the wire into the nozzle hole and
move back and forth until debris is dislodged.
several times
hose and highest pressure available (either standard
water nozzle or use your thumb over the nozzle to
create water pressure for back flush).
13
Publicité
