HAMPTON BAY AG524-ORB Guide D'utilisation Et D'entretien page 14

Assembly — Attaching the Fan Blades
9
Removing the rubber
packing mounts
The fan motor assembly (G) is shipped with rubber
packing mounts (XX) to prevent movement during
transportation. Remove the five rubber packing
mounts from the fan motor assembly and discard
prior to attaching the blade arms.
11
Fastening the blade assemblies
to the motor
WARNING: To reduce the risk of personal injury, do not
bend the blade arms (I) while installing, balancing the blades
(H), or cleaning the fan. Do no insert foreign objects between
rotating fan blades (H).
Fasten the blade assemblies (H) to the fan motor
assembly (G) by lining up the slots of the blade arms (I)
with the tabs on the motor.
Tighten the two screws and lock washers (KK) already
installed in the blade arms (I).
Repeat this procedure for the remaining blade arms (I).
All manuals and user guides at all-guides.com
10
G
XX
14
Attaching the blades to the
blade arms
Attach the blades (H) to the blade arms (I) using the
three screws with fiber washers provided with the
blade attachment hardware (AA). Insert a screw with
fiber washer (AA) into the blade arm (I), but do not
tighten.
Repeat for the two remaining screws and fiber
washers (AA).
Tighten each screw securely starting with the center
screw. Make sure the blade (H) is straight.
Repeat these steps for the remaining blades.
KK
AA
H
I
G
I
H