HAMPTON BAY AG524-ORB Guide D'utilisation Et D'entretien page 10

Assembly — Close-to-Ceiling Mounting
1
Preparing the canopy
Remove the canopy ring (B) from the canopy (C).
Remove the two non-slotted screws (FF) from the
canopy (C), and loosen the slotted screws (FF) on the
canopy (C).
Remove the canopy bottom cover (D) from the
canopy (C) by turning the canopy bottom cover (D)
counterclockwise
.
FF
A
3
Assembling the fan
Route the wires exiting from the top of the fan motor
assembly (G) through the canopy ring (B).
Make sure the slot openings are on top, and then
proceed to place the canopy over the collar at the top
of the fan motor assembly.
Align the mounting holes in the bottom of the canopy
(C) with the holes in the top of the fan motor assem-
bly (G), and fasten using the three collar mounting
screws with lock washers (JJ) previously removed.
Tighten the collar mounting screws (JJ) securely.
WARNING: Failure to completely tighten the three collar
mounting screws (JJ) could result in the fan becoming loose
and possibly falling.
All manuals and user guides at all-guides.com
2
FF
C
B
D
10
Preparing the motor
Remove three of the six collar mounting screws with
lock washers (JJ) (every other one) from the collar on
top of the fan motor assembly (G).
B
G
JJ
G
JJ
C