Festina IFM6P23/73 Manuel D'instruction page 3

I
ENGLISH INSTRUCTION MANUAL
A) DISPLAY
Minute hand
Hour hand
Second hand
B) NORMAL CROWN POSITION
1. 1ST POSITION Quick operation - date (counterclockwise)
2. 2ND POSITION Time setting (clockwise)
C) OPERATION PROCEDURE
1. Setting the time (hour, 24hour, minute and second)
2. Setting the date
D) SETTING THE TIME (HOUR, 24 HOUR, MINUTE AND SECOND)
The hour, 24 hour, minute and second are set by the same operation.
Setting procedure
HOUR & 24HOUR
Pull the crown out to the 2nd position to stop the second hand at 0 (12 o'clock).
Turn the hour/minute hands in a clockwise direction to set the time.
To ensure time is set accurately, first turn the minute hand 5 minutes ahead of desired time and then turn back (in a
counterclockwise) to the desired time.
After setting the time, use a time signal to synchronize the watch by pushing crown to the normal position to start the second
hand going.
NOTE:
Make sure you have correctly set AM/PM before setting the time.
When the day changes over, it is a.m..
(Day changes over between 0:00a.m. and 5:30a.m. or little later)
Check am./p.m. by the 24hour hand.
E) SETTING THE DATE (BY QUICK OPERATION)
Pull the crown out to the 1st position. Turn the crown counterclockwise to set the date quickly.
NOTE:
Do not set the date between the hours 9:00p.m. and 0:30a.m.. The date may not change correctly the next day.
By virtue of the regulations pursuant to the handling of waste products deriving from electronic and electrical equipment, end of lifecycle watch making
products must be selectively collected for processing. You may therefore dispose of your quartz watch making products at any of our retail outlets or any other
authorized collection point. The selective collection, processing, rating and recycling of these products helps contribute to safeguarding the environment and
protecting our health.
Date
IFM6P23/73
24hour hand
MINUTE
Normal crown position
1st position
2nd position
SECOND