Télécharger Imprimer la page

Gladiator Garageworks GARF19XXPK00 Instructions D'installation page 2

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION INSTRUCTIONS
3.
Place the refrigerator/freezer on its side on top of the cardboard
To ols | on rc
Ports
obverse
material. Make sure the door hinge is facing
Gather the required tools and parts before starting installation.
IMPORTANT:
It is important that the door hinge face upward
Tools Needed:
during the entire caster installation.
m=
'%" Socket wrench or nut
mg
%" Socket wrench or nut
driver
driver
g m
%" Wrench
Parts Supplied:
m_
Rigid casters (2)
mw
%-20x1
Ya" Lock
=
Swivel casters (2)
ont rb
ek
ts (located in
" fecaengrira
Features
mee ts 16
" t h e refrigerator/ttoozen)
mw
%-20X1
%" Hex-head
bolts (4)
Unpack Caslers
Depending on your model, the casters may be packed in either the
upper or lower compartment. Remove the box containing the
casters.
A. Top Hinge
B. Center Hinge
install Casters
4.
Remove the casters and fasteners from the box.
5.
Locate and remove the caster brackets from the FeaturePak.
"
6.
Using 4s-18 hex-head bolts, attach one rigid caster and one
Py
54 N
i h
G
swivel caster to each caster bracket. The rigid caster fits the front
of the bracket, and the swivel caster fits on the rear.
Excessive Weight Hazard
7.
Insert the hex-head bolts from the bottom and start the self-
.
locking nuts for each caster.
Use two or more people to move and install
refrigerator/freezer.
Failure to do so can result in back or other injury.
NOTE: Install the casters before you install any of the FeaturePak
items.
1.
Open the lower compartment door and remove the base grille.
Remove the grille by grasping the grille with both hands, lifting up
and pulling bottom of the grille toward you.
2.
Place the plastic skids (shipped with the refrigerator/freezer) on
the floor at least 3 ft (91.44 cm) apart. Lay a piece of cardboard
or other protective material over the skids. This will elevate the
refrigerator/freezer to allow for easier caster installation and also
protect it from scratches.
NOTE:
If the skids have been discarded or are not available,
2" x 4" boards may be used.
A. Self-locking nut
C. %6-18 x %" Hex-head bolt
B. Caster bracket
D. Caster
8.
Hold the head of the hex-head bolt with a wrench while
tightening the self-locking nuts with a socket wrench.
9.
Using a %" socket wrench, remove the four unit bolts (two on
each side) from the lower front and rear of the refrigerator/freezer.
NOTE: Do not remove the leveling bolt.

Publicité

loading