LEMAN SRM170 Manuel D'utilisation page 33

5.3 GENERAL CONTROLS
WARNING!
Before starting the saw check that the machine is working correctly, that the safety devices are perfectly
operational and that the blade slides smoothly.
Check that there are mo damaged elements, that all the parts have been assembled correctly and that they
are on perfect working order. Doubtful safety devices and damaged parts must be repaired or replaced by
specialized personnel or through a service centre authorized by the Manufacturer.
DANGER!
If the operator has any doubts whatsoever about the safety of the machine, he must stop the machine
immediately, determine the cause for the problem and, if necessary, contact the manufacturer's assistance
service.
6. INSTRUCTIONS FOR USE
6.1 BEFORE USE
WARNING!
Before starting up the machine the operator must read and assimilate this entire manual, particularly Section 4
which deals with safety.
Furthermore, before starting work, check that the machine is in order and that all the parts subject to wear and
deterioration are in perfect condition.
6.2 USE
The band saw has been exclusively designed and manufactured for cutting ferrous materials with tubular, open or
filled sections.
Use of the machine for cutting other materials or for different processing that do not comply with the uses
described in this manual, is not only to be considered improper and prohibited, but also release the Manufacturing
Company from any responsibility, both direct and indirect.
Before inserting the plug into the socket, ensure that the voltage corresponds to that marked on the identification
plate.
b
a
d
Fig 47 (Model SRM170)
6.3 OPERATION
- Connect the machine plug and switch on the machine.
- Turn the total switch:
- (d) to "ON".
- (e) to "1" (Low speed) or "2" (Fast speed).
The pilot light (a) switches on to signal that the machine is energized.
- Check that the blade guard is closed and the microswitch is pressed down otherwise the machine will not work.
b
a
c
e
f
Fig 48 (Model SRM170T)
33
c
f