Publicité
Les langues disponibles
Les langues disponibles
- That it is located near a main switch equipped with an overload cutout;
- That the power supply system is equipped with earthing which complies with the relevant standards;
o
o
- That the ambient temperature ranges between 0
C and 45
C;
- That the workplace is not in an explosive atmosphere.
After positioning the machine proceed as follows:
- Make the position of the fixing holes;
- Lift the machine and place it to the side;
- Use an appropriate size bit to drill the holes in the ground and insert the threaded screw anchors;
- Reposition the machine with its base in its position then secure the base with the screws provided.
If the machine is supplied without a base, then it must be secured by means of the two holes to a special
structure capable of supporting the weight of the machine and any unbalancing created when using it.
WARNING!
The Manufacturing Company declines any responsibility for damages caused by incorrect installation and
the use of unsuitable bases.
CLEANING THE MACHINE
After positioning the machine (with the work bench level and before making the connections), clean off all the
protective oils on the painted and unpainted surfaces with detergent or mineral naphtha.
These liquids must not be sprayed on; use a cloth dampened with the liquid, then dispose of the cloth in
accordance with the relevant antipollution regulations.
CONNECTIONS
- Ensure that the mains voltage corresponds to that of the machine motor indicated on the identification plate.
- Connect the line cable of the machine to an electrical board equipped with an automatic main switch (magneto
thermal type), with earth connection ad stipulated by the safety standards in force, capable of protecting the
machine from overloading and short-circuiting.
- Ensure that the cutting band rotates in the direction of the arrow on the safety guard which covers it and that the
saw teeth are facing the correct direction.
Remove the handgrip control and the rod with bar-stop from the supplied accessories and proceed as follows:
ROD WITH BAR STOP
O
O
Fig 18
Fig 19
Fig 20
- Insert the threaded rod into its seat and lock it (Fig 18, 19, 20).
COOLANT
- Pour the coolant, which consists of water and emulsifiable oil (13 l.) into the recovery tank. Dilute the emulsifiable
oil as directed by the manufacturer (normally approx. 10% oil).
- Make sure that the quantity of coolant which is distributed during the cutting operation is sufficient. The blade
must be well lubricated.
- Before operating the machine, check its general efficiency and familiarize yourself with the control devices and
their functions.
32
Publicité
