Publicité
Les langues disponibles
Les langues disponibles
1. Insert the dowels C into the holes.
2. Place the long brackets G over the top holes. Fix them using the screws B. The
hole on the support facing upwards.
3. Place the short brackets H over the bottom holes. Secure them using screws B.
The hole on the support facing down.
4. Insert the fasteners F into the supports G, secure them using the screws E and
nuts K.
5. Fix the towel rail by placing it between the fixings F and the spacers J. Make sure
that the narrowest part of the spacer C faces the inside of the radiator.
6. Aim everything using the screws D and cover them with the screw covers I.
COMMISSIONING
1. Check that the appliance is powered by the electrical network, then test the various
functions of the thermostat and adjust the setpoint temperature.
2. In the event of an operating anomaly, check that the device is powered by the
electrical network. If the device is properly powered and does not work properly,
notify your installer or the builder.
IV. INSTRUCTIONS FOR USE
1 / ) Control panel and screen
6 Button:
Standby
Fan heater function & Mode selection
Temperature adjustment +: Press this button for a rapid increase in
temperature.
This button is also used to select the time slots when setting the daily daily schedule.
42
Publicité
