Publicité
Les langues disponibles
Les langues disponibles
This warranty does not cover the following: machines used for rental purposes,
damage resulting from shipping (claims must be filed with freighter), accident,
abuse, act of God, misuse, or neglect. Neither is damage from repairs or altera-
tions performed by non-factory authorized personnel or failure to install and oper-
ate equipment according to the guidelines put forth in the instruction manual.
The manufacturer will not be liable to any persons for consequential damage, for
personal injury, or for commercial loss.
WARRANTY DOES NOT APPLY TO FAILURES DUE TO:
•
Freight damage
•
Damage due to chemical deterioration, scale build up, rust, corrosion or
thermal expansion
•
Freeze damage
•
Damage caused by parts or accessories not obtained from an authorized
dealer or not approved by the manufacturer.
•
Normal wear of moving parts or components affected by moving parts.
ENGINE
Covered by engine manufacturer warranty. See engine manual.
HIGH PRESSURE PUMP (DEFECTS IN MATERIAL AND WORkMANSHIP)
Five (5) years from date of purchase.
FRAME (DEFECTS IN MATERIAL AND WORkMANSHIP)
One (1) year from date of purchase.
ACCESSORIES (DEFECTS IN MATERIAL AND WORkMANSHIP)
Includes nozzles, hoses, spray guns, wands, tires, feet
Ninety (90) days from date of purchase.
OPERATIONAL
ISSUE
Engine will
not start
(see Engine
Owner's
Manual for
further engine
troubleshooting)
No or low
pressure
(initial use)
TROUBLE SHOOTING GUIDE
POSSIBLE CAUSE
No fuel
Pressure builds up after
two pulls on the recoil
starter or after initial use
Choke lever in the "No
Choke" position
Spark plug wire
not attached
Spray wand not in
high pressure
Low water supply
Leak at high pressure
hose fitting
Nozzle obstructed
SOLUTION
Add fresh fuel
Squeeze gun trigger to relieve
pres sure
Move choke to the "Choke"
po si tion
Attach spark plug wire
See how to Use Spray
Wand instructions in the
Operation Section
Water supply must be at
least 5 gpm @ 20 PSI
Repair leak. Apply sealant
tape if necessary
See Nozzle Cleaning instructions
in the Maintenance section
20- ENG
Publicité
