Kubota GZD15-II Instructions De Montage page 8

6
C Bag base side
(Right side lower lift arm)
1. Remove the headed pins and take off the arm cam
from the bag base.
2. At the right side, using the arm cam, collars and
washers, install the lower lift arm.
3. Fix the arm cam with the headed pin and the snap pin.
A Set the washers on the inside of the bag base only.
(1) Headed pin
(2) Snap pin
(3) Washer
(4) Bag base
(1) Arm cam
(2) Collar
(3) Lower lift arm
(4) Bag base
All manuals and user guides at all-guides.com
(Left side lower lift arm)
Using bolts, washers, collars and nuts, install the lower lift
arm to the bag base.
Tightening torque : 40 to 50 N-m (4.1 to 5.1 kgf-m)
A Set the washers on both sides. Insert the bolt from the
A Apply grease between the lift arm and the bag base.
(1) Bolt
(2) Washer
(3) Collar
(Upper lift arm)
The position of the hole for setting is different between
GZD15 and GZD21.
Using bolts, washers, collars and nuts, install the upper lift
arms to the bag base.
Tightening torque : 40 to 50 N-m (4.1 to 5.1 kgf-m)
A Set washer on both sides. Insert the bolt from the
A Apply grease between the lift arm and the bag base.
(1) Bolt
(2) Upper lift arm
(3) Bag base
outside.
(4) Nut
(5) Lower lift arm
(6) Bag base
outside. (Same as the left side lower lift arm.)
(A) for GZD15
(B) for GZD21