Publicité
Les langues disponibles
Les langues disponibles
OPEN AND FOLD THE SCOOTER
Opening the scooter
1. With the scooter closed as in Fig 2, release the handlebar by moving the safety
lock A upwards (located on the lower part of the handlebar support tube and
green in colour) as indicated by the red arrow in Fig 1, then, simultaneously, press
key B downwards as indicated by the black arrow in Fig 1;
2. Bring the handlebar tube to a vertical position, taking care to keep the platform still
and giving a strong and decisive blow in the final part of the stroke so that the
mechanisms lock perfectly;
ATTENTION: if at the end of the operation button B should remain partially
pressed, it would mean that the mechanisms are not perfectly tightened
therefore, it will be necessary to repeat the steps of point 1, to release the
handlebar again, and then those of point 2, increasing the force of the blow
in the final part of the race. Always check that button B always returns to its
end of travel and NEVER stays pressed, even lightly.
3. The scooter will be correctly opened when you hear the click of the handlebar
tube and button B has fully completed its stroke.
HOW TO RECHARGE THE BATTERY
Before first use, charge the battery to 100% capacity.
To make sure you reach your destination, we recommend fully charging the battery
at the latest when the display only shows two bars
Note:
The battery must be charged every 30 days, even if the scooter is not used;
if the battery is not charged regularly, it will lose efficiency until it is completely di-
scharged; in this case, we will not be able to recognize the guarantee on the product.
Charging procedure
1. Open the charging socket protective cap located on the side of the scooter and
connect the charging plug of the charger, paying attention to the direction of
insertion;
2. Connect the charger to the wall socket at 220V
3. The charging process is in progress with red charger LED light. The charging
process is completed when the charger LED turns green: the battery is charged
to 100% capacity;
4. Disconnect the charger from the wall socket and then the charging socket from
the e-scooter;
;
31
Publicité
