Publicité
Les langues disponibles
Les langues disponibles
FIRST USE
Assembly and fixing of the front brake lever and installation of
the grips
Before using the VELOCIPTOR ES 82W, some installations and adjustments need to
be made. First, unpack the vehicle chassis:
1.
Insert the ring with the front brake lever into the right side of the handlebar
support, adjust the angle according to your height and riding style; tighten the
ring to the handlebar support by tightening the fixing screw;
2.
Install the horn (bell) on the left side of the handlebar holder and tighten it by
tightening the fixing screw;
3.
Assemble the handlebar grips to the main frame of the vehicle. Connect the grip
connector to the handlebar support connector taking care to respect the colors
and insertion direction of both connectors (white to white and red to red). In-
sert the threaded part of the first knob (right or left) into the respective hole on
the sides of the frame. Then, while holding the main frame, screw it clockwise
(see pictures below) until the threaded part of the knob is fully seated on the
handlebar mount;
4.
Install the front reflector between the display and the accelerator control, adjust
its angle and tighten the fixing screws;
5.
Check all components carefully to make sure the steering is installed correctly
and that all connecting parts are secure and in good working order.
Left knob
Left connector
Front reflector
29
Right connector
Right knob
Publicité
