cecotec THERMOSENSE 420 VINTAGE INOX Manuel D'instructions page 36

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Handle
2. Lid
3. Spout
4. Filter
5. Temperature gauge
6. Base
7. Water level gauge
8. Lever
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
appliance.
2. BEFORE USE
This appliance is packaged in a way as to protect it during transport. Take the appliance
-
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
Make sure all parts and components are included and in good conditions. If there is any
-
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Before using the appliance for the first time, boil water twice without cleaning agents.
-
3. OPERATION
1. Remove the lid and fill the kettle with water while watching the water level gauge.
2. Place the lid on the kettle.
3. Place the kettle on the power supply base.
4. Press the lever down: the corresponding LED indicator will light up. The kettle will start
boiling water. With the exterior temperature gauge, you will be able to view the water
temperature at all times.
5. After boiling the water, the appliance will switch off automatically.
6. Before serving water, wait until it stops boiling.
7. Do not open the lid when serving.
36
THERMOSENSE 420 VINTAGE INOX/LIGHT BLUE/LIGHT GREEN/LIGHT YELLOW/LIGHT BEIGE/LIGHT RED