Publicité
Les langues disponibles
Les langues disponibles
VACUUM BLENDING WITH THE
SINGLE-SERVE FRESHVAC™ CUP - CONT�
IMPORTANT: Review all warnings
on pages 4–7 before proceeding.
10 Place the unplugged motor base
on a clean, dry, level surface such
as a countertop or table. Press
downward on the motor base to
adhere the suction cups to the
work surface. Plug the motor base
into a wall outlet.
14
11 Turn the Single-Serve FreshVac
Cup upside down and install onto
the motor base. When the unit is
correctly locked into the motor
base, program lights will illuminate.
12 If using a pre-set program, select
the program that best suits your
recipe. The pre-set feature will
automatically stop the unit at the
end of the program. To pause
the unit at any time, press the
currently active program a
second time. Reference page 11
for program descriptions.
13 When blending is complete, lift
the cup up and out of the motor
base. Pressure must be released
before opening the cup. (see step
14 below). DO NOT store contents
in the cup with the Pro Exactor
Blades® Assembly attached.
14 Open the Flip & Seal Lid by pressing
the tab and lifting. To release the
vacuum seal, gently lift the FreshVac
Tab. Air will enter the cup, making it
easy to remove the blade assembly.
DO NOT PULL TAB OUT
15 Close the Flip & Seal Lid, pressing it
until it clicks into place.
16 Turn cup over so blade assembly
is on top. Rotate blade assembly
counterclockwise to remove. To
take your blended contents on the
go, place the spout lid on cup and
turn clockwise to seal.
17 Unplug the unit when finished. To lift
the motor base, place your hands
underneath both sides of it and
gently pull the unit up and toward
you. Refer to the Care & Maintenance
section for storing instructions.
ninjakitchen.com
15
Publicité
