Publicité
Les langues disponibles
Les langues disponibles
VHG SERIES GAS FRYERS
Hot oil and hot parts can cause burns. Use care when operating,
cleaning, and servicing the fryer.
Spilling hot fryer compound can cause severe burns. Do not
move fryer without draining all frying compound from the tank.
Disconnect the power supply to the fryer before servicing.
LUBRICATION
There are no parts that require lubrication.
FLUE VENT INSPECTION
When the fryer is cool, inspect annually. Check the flue and clear any obstructions.
ANNUAL INSPECTION
Contact an authorized service contractor for an annual inspection of the fryer.
SERVICE IN THE US AND CANADA
Contact the factory, the factory representative or authorized service contractor in your area to
perform maintenenace and repairs. For a complete listing of Service and Parts depots refer to
www.vulcanequipment.com
PILOT OUT – If the pilot is out, the digital control displays the following message:
NO OR LOW GAS SUPPLY – If no action is taken after 90 seconds, the heat demand is
disabled. The digital control displays the following message:
The fryer must be turned off, then back on to re-initialize the control and to have normal
functions resumed.
OPEN PROBE – If an open probe is detected, the heat demand is disabled. All operator
buttons are disabled. The digital control displays the following message:
VULCAN
MAINTENANCE
ERROR MESSAGES
"A" Solid State Knob – PLt
"A" Solid State Knob – PLt
"A" Solid State Knob – oP
-25-
F-47679 Rev. A (3-20)
Publicité
