Enter The Seam From Outside; Place On Existing Seam; Exit From The Seam - Freund Seaming Pro Mode D'emploi

EN USER MANUAL

16. ENTER THE SEAM FROM OUTSIDE

The tension lever is closed.
The Seaming Pro is positioned in front of the
unclosed seam. Enter slowly and gently. It is not
necessary to pre-seam the panels.

17. PLACE ON EXISTING SEAM

The Seaming Pro can be placed anywhere on
the prefabricated seam. For the single standing
seam, a machine length (min. 30 cm/12 inch)
must be pre-seamed with the single standing
seam closer. For the double standing seam, a
minimum of 30 cm (12inch) must be pre-seamed
by hand with a double squareseam folder. The
seaming machine must be positioned centrally
at the area where the single standing seam and
double standing seam meet. Once the correct
position has been reached, the tension lever can
be closed without much effort.
When seaming clips, please note that the material
to be processed increases in thickness. For this
reason, clips must be run over slowly and care-
fully. If the thickness of the material is greater
than the allowed limits (see table on page 27),
the seaming is done at your own risk.
Subject to technical changes. Please observe the safety instructions.
33
Caution: The machine must not enter an alrea-
dy finished double standing seam. Otherwise,
pressure marks and an incorrect closing of the
seam will be the result.
The Seaming Pro must not be placed and clamped
on the pre-profiled panels without pre-seaming.

18. EXIT FROM THE SEAM

When the Seaming Pro has reached the end of
the seam, the user turns off the machine.
The Seaming Pro can be removed from the seam
at slow speed. This will also close the remaining
seam (approx. 30 cm). The machine must be
adjusted manually according to the roof pitch.
We recommend closing the last 30 cm (12inch)
using a double squareseam folder or a single
squareseam folder.
When approaching an obstacle (wall, chimney
etc.), the user also switches off the machine. The
Seaming Pro can be removed from the seam by
opening the tension lever.
The remaining seam must be closed with a double
squareseam folder or a single squareseam folder.
WWW.FREUND-CIE.COM