Commissioning; Possible Applications; Sheet Thicknesses; Pressure Adjustment - Freund Seaming Pro Mode D'emploi

EN USER MANUAL

5. COMMISSIONING

Read the owner´s manual carefully before use.
Make sure that only trained and instructed per-
sonnel use the Seaming Pro. Fasten the holder for
the cordless screwdriver to the folding machine
with the fastening screws included in the scope
of delivery. The ring bolt can be fixed at the front
or at the back.
Place the cordless screwdriver in the mounted
holder and lock the drill chuck on the drive. Al-
ternatively, you can lock the cordless screwdriver
on the rear of the seaming machine (e.g. for
processing facades).
It is recommended to carry out a seaming test
and check whether the desired seam quality has
been achieved. Please adjust the pressure setting
if necessary. Before commissioning and during
operations check that all screws of the forming
rolls and rubber drive rollers are tightened.
The machine can be used to process sheets of
metal of different materials in different thicknes-
ses and hardnesses. If you are using sheets that
are below or above the commercially available
qualities, it is recommended that you contact the
Freund-Service.
The machine operates in a temperature range of
-10° C to +50° C (14F – 122F). At lower tempe-
ratures, the machine must be stored in the PVC
case and in temperature-controlled rooms.
Special care must be taken to ensure that after
each use the machine, especially the forming and
driving rolls, are cleaned of residues.
Subject to technical changes. Please observe the safety instructions.
27

6. POSSIBLE APPLICATIONS

The Seaming Pro can be used with all common
materials in seaming quality (roll- and kink-free;
especially color and galvanized sheets can be
seamed).

7. SHEET THICKNESSES

The Seaming Pro is factory set to common ma-
terials. Adjust the pressure setting if necessary.
Titanium zinc
Copper
Aluminum
Colored Steel
Galvanized Sheet Metal
Stainless Steel (max. 1.4301/
V2a und max. 500N/mm²)
Stainless Steel forming
rollers are available as acces-
sories Item no. 93000010

8. PRESSURE ADJUSTMENT

The contact pressure can be changed by turning
the pressure adjustment screw.
Up to 0,70 mm
(21 ga)
Up to 0,70 mm
(21ga)
Up to 0,70 mm
(21ga)
Up to 0,60 mm
(22 ga)
Up to 0,60 mm
(22 ga)
Up to 0,50 mm
(24ga)
WWW.FREUND-CIE.COM