La Crosse Technology CA84688 Manuel D'instructions page 3

Setup Preparation
Items you will need to setup your station (not included):
1. Phillips head screwdriver for assembly.
2. Fresh Batteries:
3 (three) AA alkaline batteries for the station
2 (two) C alkaline or lithium batteries for the Wind sensor.
For best results:
• Remove weather station and sensor from the package and place together on a table or bench, within
easy reach.
• Place batteries and screwdriver within reach of setup location.
• Keep sensor and weather station within 5-10 feet for at least 15 minutes after installing batteries. This
allows the sensors and station to sync properly and ensures a strong connection.
Quick Setup
1. Power up: Insert 2-C batteries into the Wind/TH sensor. Then, insert 3-AA batteries into the weather
station.
2. Configure basic settings. Set Time, Date etc.
3. After 15 minutes, place sensor outside (see mounting instructions on
Wind Speed sensor
Red LED on sensor: The sensor has a red LED light that flashes once during each sensor signal
transmission.
CA84688
TX141Wv2
Wind Speed Weather Station
page
AA
AA
AA
Note: Batteries are
not included
14).
Weather Station
CA84688
Page | 3